R7008SB Channel Modes
#1
Thread Starter
R7008SB Channel Modes
Hi,
I want to use the above receiver in a small jet. The receiver Sbus output will be connected to a gyro for flight controls. I want to change the Channel Mode to mode D to use channels 9-15 for auxiliaries.
Can you confirm that in this mode the Sbus stream will still output channel 1-8 data?
Thanks,
Malcolm
I want to use the above receiver in a small jet. The receiver Sbus output will be connected to a gyro for flight controls. I want to change the Channel Mode to mode D to use channels 9-15 for auxiliaries.
Can you confirm that in this mode the Sbus stream will still output channel 1-8 data?
Thanks,
Malcolm
#2
In Mode D you will get channels 9 - 15 on servo ports 1 - 7 on the RX. S.Bus will connect to servo port #8.
S.Bus can connect to any channel, it depends on how you assign you servos. The modes allow you to get certain channels on the hard wired ports on the RX.
S.Bus can connect to any channel, it depends on how you assign you servos. The modes allow you to get certain channels on the hard wired ports on the RX.
#4