Eclipse 7 question
03-01-2005 | 02:54 PM
#1
Thread Starter
Senior Member
My Feedback: (17)
Joined: Jan 2003
Posts: 2,106
Likes: 0
Received 0 Likes
on
0 Posts
From: San Antonio,
TX
Eclipse 7 question
Hi, I have an Eclipse 7 and need some help. I'm wiring a P51 with flaps and retracts. Do I have the channel line up correct?
1. right aileron
2. rudder
3. engine
4. elevator
5. retracts
6. left aileron
7. flaps
My second question is can I control the flaps with either the channel 7 switch or the flight mode switch vs. the VR 2 knob? What I'm wanting to do is have it set on the 3 position switch to have them set at full up, 15% down and full down? Is this possible with the Eclipse? If not then what about with the Optic 6?
1. right aileron
2. rudder
3. engine
4. elevator
5. retracts
6. left aileron
7. flaps
My second question is can I control the flaps with either the channel 7 switch or the flight mode switch vs. the VR 2 knob? What I'm wanting to do is have it set on the 3 position switch to have them set at full up, 15% down and full down? Is this possible with the Eclipse? If not then what about with the Optic 6?
03-02-2005 | 11:55 AM
#2
Senior Member
Joined: Nov 2004
Posts: 675
Likes: 0
Received 0 Likes
on
0 Posts
From: Poway,
CA
RE: Eclipse 7 question
ORIGINAL: cruzomatic
Hi, I have an Eclipse 7 and need some help. I'm wiring a P51 with flaps and retracts. Do I have the channel line up correct?
1. right aileron
2. rudder
3. engine
4. elevator
5. retracts
6. left aileron
7. flaps
My second question is can I control the flaps with either the channel 7 switch or the flight mode switch vs. the VR 2 knob? What I'm wanting to do is have it set on the 3 position switch to have them set at full up, 15% down and full down? Is this possible with the Eclipse? If not then what about with the Optic 6?
Hi, I have an Eclipse 7 and need some help. I'm wiring a P51 with flaps and retracts. Do I have the channel line up correct?
1. right aileron
2. rudder
3. engine
4. elevator
5. retracts
6. left aileron
7. flaps
My second question is can I control the flaps with either the channel 7 switch or the flight mode switch vs. the VR 2 knob? What I'm wanting to do is have it set on the 3 position switch to have them set at full up, 15% down and full down? Is this possible with the Eclipse? If not then what about with the Optic 6?
03-03-2005 | 11:07 AM
#3
Thread Starter
Senior Member
My Feedback: (17)
Joined: Jan 2003
Posts: 2,106
Likes: 0
Received 0 Likes
on
0 Posts
From: San Antonio,
TX
RE: Eclipse 7 question
But what I want is to control the flaps with the land 3 position switch? Is that possible?
Please note the flaps are control by a single servo.
Please note the flaps are control by a single servo.
