RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 8
1
2
3
Last »
Search: Posts Made By: neb
Showing results 1 to 25 of 194
Search took 0.75 seconds.
Forum: Speed - RC Gas Boats
07-13-2008, 12:14 PM
Replies: 8
Views: 789
Posted By neb

RE: Recommendations

all i did was change the carb, it seems to be running as well as they do in the vids now
Forum: Speed - RC Gas Boats
05-23-2008, 10:17 AM
Replies: 6
Views: 2,014
Posted By neb

RE: fighter cat 57 53" "arrowshark"

i recently bought a boat off them, it has a mixture of the new and old hardware and you can really tell the difference
Forum: Speed - RC Gas Boats
09-13-2006, 03:38 PM
Replies: 86
Views: 11,015
Posted By neb

RE: Gas Boat from china

i believe for the same sort of money you can get a similar boat from radio control 2005 which looks much better quality
radiocontrol 2005
Forum: Speed - RC Gas Boats
08-19-2006, 04:41 AM
Replies: 4
Views: 720
Posted By neb

RE: Boat Rookie

im also a boat rookie so i might as well ask a question here, i have a choice of a hull similar to zcopters, or a hull similar to a v24, which one is best for higher speeds?
Forum: Speed - RC Gas Boats
08-13-2006, 10:41 AM
Replies: 12
Views: 4,662
Posted By neb

RE: aquacraft V24 with zenoah

is this because the v24 hull is weak, or not just built for speed?
Forum: HPI Monster Truck Forum
03-06-2005, 04:02 PM
Replies: 4
Views: 699
Posted By neb

RE: Anyone with Hyper 8 port in a Savage?

Is the hyper a drop in engine on the savage or are new engine mounts needed?
Forum: HPI Monster Truck Forum
02-19-2005, 05:26 AM
Replies: 25
Views: 1,727
Posted By neb

RE: stupid savage

I had the same problems when the engine was started the servos went off by themselves and when the engine was off they worked fine, it was my receiver, which was stock at the time, the receiver is...
Forum: RC Giant Scale Cars
02-11-2005, 05:42 AM
Replies: 6
Views: 1,440
Posted By neb

RE: Max Bashing magazine...

Seen it too, looks good[8D]
Forum: Traxxas Monster Truck forum
02-11-2005, 05:37 AM
Replies: 3
Views: 546
Posted By neb

RE: Honest answers on REVo power

No i do not find mine under powered, on the sraights it just about keeps up with a s-25. The acceleration is good. I find i can keep up with some truggies and beat them as well, such as the stadium...
Forum: HPI Monster Truck Forum
02-11-2005, 04:26 AM
Replies: 20
Views: 1,113
Posted By neb

RE: savage as great as you all say

I own a revo and a savage, i think the revo is better as its actually been alot more reliable. The savage couldnt finish any races as the slipper melted the diff gears and cases went after 11 tanks...
Forum: Traxxas Monster Truck forum
02-08-2005, 12:28 PM
Replies: 10
Views: 651
Posted By neb

RE: Houston I think i got a prob. here.

Sounds similiar to a problem i once had as i started the engine reved it a bit and nothing, the clutch obviously wasnt engaging so i just reved it up a little higher after letting the engine warm up...
Forum: HPI Monster Truck Forum
02-08-2005, 12:21 PM
Replies: 10
Views: 542
Posted By neb

RE: oil wt in savage 25

I thought it used 45wt as standard as i went down to 25wt for racing and found it was more plush
Forum: HPI Monster Truck Forum
02-08-2005, 12:19 PM
Replies: 19
Views: 984
Posted By neb

RE: what brand of fuel do you use?

HPI recommends tornado 20% fuel and the engines only under warrenty if you run it on that fuel, they can tell if different fuel has been used. I use 25% Tornado and I find it to be very good, i was...
Forum: RC Monster Trucks
02-05-2005, 05:03 AM
Replies: 3
Views: 362
Posted By neb

RE: Need Help with my Revo Remote Controler

I put a battery pack in mine, but i dont have it anymore. I just took the two wires leading to the battery pack holder and soldered a 3 pin battery connector to it, the battery had a 3 pin connector...
Forum: Traxxas Monster Truck forum
02-04-2005, 11:18 AM
Replies: 9
Views: 1,138
Posted By neb

RE: Replacing a broken antenna wire?

On my FG i had a KO receiver and the wire was far too short, i soldered another bit on so it stuck out the body shell and i have had no problems with it. You should be able to get some off your LHS
Forum: Traxxas Monster Truck forum
02-02-2005, 11:02 AM
Replies: 17
Views: 884
Posted By neb

RE: Tuning by temp?

The breather is a pressure line and needs to be left on or the engine wont run properly, i beleive it keeps enough pressure in the fuel tank so the engine gets a steady amount of fuel and enough fuel
Forum: HPI Monster Truck Forum
01-30-2005, 04:17 AM
Replies: 14
Views: 740
Posted By neb

RE: one way bearing

Sorry dont listen to me, i didnt relise you were using a different engine, ill have to read the post a bit more carefully next time:eek:
Forum: HPI Monster Truck Forum
01-30-2005, 04:12 AM
Replies: 12
Views: 951
Posted By neb

RE: Throttle Problem; please help this newbie out, savage keeps going wide open after brake applied

Or you could buy the new HPI CAM servo saver, it comes with a throttle mod where you get a stronger return spring and stronger collar for the servo horn, i was having similar problems but they werent...
Forum: HPI Monster Truck Forum
01-28-2005, 03:51 AM
Replies: 14
Views: 1,379
Posted By neb

RE: Tires For Sand and Loose Dirt

The swamp dogs, I would say are your best bet as they could run on any surface. They look like they would work well on sand too. They also are a very nice looking tire[8D]
Forum: HPI Monster Truck Forum
01-28-2005, 03:48 AM
Replies: 14
Views: 740
Posted By neb

RE: one way bearing

On the new HPI rotostart it tells you to hold it for 5 seconds then let off.
Forum: Traxxas Monster Truck forum
01-27-2005, 04:09 PM
Replies: 12
Views: 645
Posted By neb

RE: failsafe

On my FG the failsafe failed to work and the truck ended up in the wall, the area it was run in does have alot of interference with at least one model getting interference a day
Forum: HPI Monster Truck Forum
01-27-2005, 04:01 PM
Replies: 4
Views: 458
Posted By neb

RE: Is is a 1 way?

the one way bearing has gone
Forum: Traxxas Monster Truck forum
01-26-2005, 11:26 AM
Replies: 12
Views: 645
Posted By neb

RE: failsafe

The failsafe is meant to hit the brakes if theres interference or the batterys low, but i have found it doesnt always work
Forum: HPI Monster Truck Forum
01-26-2005, 11:13 AM
Replies: 15
Views: 522
Posted By neb

RE: Savage 25 accesories?????

Hi
is the servo saver the new CAM type or like a servo horn?, if you can post some pics it would be easier to help. How much torque has the servo got?, as it is probably for steering. The reverse...
Forum: Traxxas Monster Truck forum
01-24-2005, 11:51 AM
Replies: 25
Views: 1,087
Posted By neb

RE: Looking to get a REVO, a few questions & need opinions

Yes the shocks work very well, handles alot better than nearly all monster trucks, so far i have found the revo is alot more reliable than the savage, the customer service is excellent, I ordered a...
Showing results 1 to 25 of 194
 
Page 1 of 8
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.