RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: jweger77
Showing results 1 to 25 of 30
Search took 0.48 seconds.
Forum: Giant Scale Aircraft - General
04-30-2010, 04:14 PM
Replies: 1
Views: 980
Posted By jweger77

Bud nosen trainer 100"

Good afternoon all. Have a bud nosen trainer kit that I just picked up. Looking for a plan set on it. Anyone know of where I can get a set. Thanks!
Forum: Engine Conversions
09-07-2009, 12:59 PM
Replies: 11
Views: 2,103
Posted By jweger77

RE: Craftsman 32cc Powered Giant Super Sportster

Cool, so am I looking at a Poulan engine then on from this craftsman wacker? I really like the engine though it could stand to have a better ring thrown in it. We'll see how the compression...
Forum: Engine Conversions
09-05-2009, 05:40 PM
Replies: 11
Views: 2,103
Posted By jweger77

RE: Craftsman 32cc Powered Giant Super Sportster

10lbs out of that? I'd think I'd be pretty disappointed if that were the case. Have a 25cc Mac conversion in a Senior Telemaster that gets almost 11lbs and that's completely stock. Flew the...
Forum: Engine Conversions
09-04-2009, 11:23 AM
Replies: 11
Views: 2,103
Posted By jweger77

RE: Craftsman 32cc Powered Giant Super Sportster

First tach numbers are 6600 with a Bambula 18x8. Got some old gas that has evaporated quite a bit so the mix is way too oily...got some fresh gas today and we'll see how it does. Weight right now...
Forum: Engine Conversions
09-01-2009, 08:17 PM
Replies: 11
Views: 2,103
Posted By jweger77

Craftsman 32cc Powered Giant Super Sportster

Good evening all...finally teaching this engine to run with some power and a great idle! All it took was ditching the 7mm carb and going with a 11.13mm WT 570 and we're all good! I will post some...
Forum: Engine Conversions
05-25-2009, 04:35 PM
Replies: 332
Views: 49,483
Posted By jweger77

RE: WHAT A DEAL

http://www.youtube.com/watch?v=nqasNr_VdnsShort video shot with the camera phone....not the best but it gives a good idea!
Forum: Engine Conversions
05-24-2009, 08:35 PM
Replies: 332
Views: 49,483
Posted By jweger77

RE: WHAT A DEAL

Well, i have finally gotten around to getting some work done on this and have fired up the engine and it runs great! With a 16-6 getting between 9.5-11 lbs of thrust depending on the prop...
Forum: Gas Engines
03-19-2009, 02:11 PM
Replies: 4
Views: 761
Posted By jweger77

RE: Sachs 5.8 Vibration

crank is straight as an arrow...mid range is anywhere from 4000-6000 or so....
Forum: Gas Engines
03-18-2009, 10:27 PM
Replies: 4
Views: 761
Posted By jweger77

Sachs 5.8 Vibration

Hello everyone...have picked up a Sachs 5.8 (95cc) for a Corsair build. I've heard a lot of bad things about vibration with this engine...It does appear to vibrate a pretty good amount in mid range....
Forum: Engine Conversions
02-29-2008, 08:42 PM
Replies: 332
Views: 49,483
Posted By jweger77

RE: WHAT A DEAL

I'm finishing up the telemaster test bed for the MB...then time to wait for some good warmer weather here in the midwest! Will fire up the engine and see how she works as a plane engine! Should be...
Forum: ARF or RTF
02-29-2008, 08:37 PM
Replies: 6
Views: 2,865
Posted By jweger77

RE: Hobby Lobby Senior Telemaster w/ Zenoah G20ei

I like the break down system you have for this...it's very common sense....finishing mine up for the spring. Kit built...removable tail w/ wing struts, re-inforced fuse and a converted 25cc gasser...
Forum: Gas Engines
05-26-2007, 04:04 PM
Replies: 3
Views: 795
Posted By jweger77

RE: Need a G-62 Cylinder Head

Unreal....engine is a year old....though not bought as a Zenoah....moped co. conversion...damn....what can you do?
Forum: Gas Engines
05-26-2007, 03:56 PM
Replies: 3
Views: 795
Posted By jweger77

Need a G-62 Cylinder Head

Hey everyone...looking for any suggestions on where to buy a G-62 cylinder head for a good deal....best price I've found yet is 89.99 + shipping...any suggestions?? Thanks!!
Forum: Electric General Discussion
02-25-2007, 04:20 PM
Replies: 14
Views: 1,619
Posted By jweger77

RE: GP Super Sporster EP

good points about their recommendations...yes, I should pick up a wattmeter as well....was just hoping to avoid it right away!! Thanks much...
Forum: Electric General Discussion
02-21-2007, 11:30 PM
Replies: 14
Views: 1,619
Posted By jweger77

RE: GP Super Sporster EP

That's interesting....I wonder if a 12x8 makes that big of a difference?? And what difference does the apc make?? Times like these I wish I had a wattmeter!! well, I was most aggravated that they...
Forum: Electric General Discussion
02-21-2007, 01:43 PM
Replies: 14
Views: 1,619
Posted By jweger77

RE: GP Super Sporster EP

Well, an update...I emailed Great Planes Tech. Ass. Dept...inquiring about different prop size/pitches....and I was told that they did NOT test this plane with anything other than included 12x10...
Forum: Electric General Discussion
02-15-2007, 10:12 PM
Replies: 14
Views: 1,619
Posted By jweger77

RE: GP Super Sporster EP

Well, I won't have to worry about the lipo factor as I'm running with NIMH packs....did anyone experiment with diff props on stock config?? Or did everyone just jump right to brushless and lipos?
Forum: Electric General Discussion
02-15-2007, 06:16 PM
Replies: 14
Views: 1,619
Posted By jweger77

GP Super Sporster EP

Hey all, I've got a new SS EP and would like to know if anyone has used diff props other than the piece of junk that came with the plane? I was wondering what size of APC E prop would be good. I'm...
Forum: Golden Age, Vintage & Antique RC
02-15-2007, 05:00 PM
Replies: 2
Views: 793
Posted By jweger77

Vintage Taurus plane

Hey guys found this on ebay and was wondering what it might be worth?? Any ideas???...
Forum: Engine Conversions
02-08-2007, 06:40 PM
Replies: 15
Views: 1,394
Posted By jweger77

Is PCM necessary to fly a converted gasser with?

Hey all, I'm mulling over what radio to pick up for a senior telemaster with a converted 25cc Mac engine...and I'm wondering is PCM the only way to go with converted gassers?? Will FM run glitch...
Forum: Engine Conversions
08-30-2006, 10:29 AM
Replies: 18
Views: 3,860
Posted By jweger77

RE: Has anyone had an rc vehicle explode or catch fire?

Here you all are.....can you say 200 mph + jet fuel + tree = explosion???

http://www.youtube.com/watch?v=ENcIZVx-o9c

Get your extinguishers!!!
Forum: Engine Conversions
08-24-2006, 10:31 PM
Replies: 332
Views: 49,483
Posted By jweger77

RE: WHAT A DEAL

Thanks for the info! I will have to check those out a bit more.....my dad and I will be making some canister mufflers that will go in th e fuse...I just need a header.....he's making one for a...
Forum: Engine Conversions
08-23-2006, 10:17 PM
Replies: 332
Views: 49,483
Posted By jweger77

RE: WHAT A DEAL

Hey Flip Flop..........I see that Horizon still sells the pipe and header set.....I'll be making a canister muffler to keep her good and quiet....are there any other header options you're aware of?? ...
Forum: ARF or RTF
08-20-2006, 11:42 PM
Replies: 53
Views: 23,025
Posted By jweger77

RE: Senior Telemaster ARF modifications

http://image.rcuniverse.com/gallery/photos/248799/lg-63198.jpg

Building one with a converted 25cc blower motor...I already have a Telemaster 66 that I first flew when I was 13.....still is a...
Forum: Engine Conversions
08-20-2006, 11:37 PM
Replies: 5
Views: 1,175
Posted By jweger77

RE: Needed your suggestions for senior telemaster

Here is the framed up...but not yet sheeted fuse with the monster on front...(it's a McCulloch 25cc leafblower..MB290)...Looks nice doesn't it...a bit heavy...but I overbuild anyways....and now I can...
Showing results 1 to 25 of 30
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.