RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: NV Flyer
Showing results 1 to 25 of 49
Search took 0.74 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-20-2003, 11:56 PM
Replies: 7
Views: 1,401
Posted By NV Flyer

RE: 9C Snap Roll Switch

Have you tried with the SAFE-MOD set to FREE?
If it works then, it has something to do with your landing gear switch.
Page 51 of the manual mentions something about it. V1.2.
Forum: Foamies! - RC Electric Foam Aircraft
09-20-2003, 11:15 PM
Replies: 31
Views: 7,666
Posted By NV Flyer

RE: Zagi XT

I have a few flights on my XT.
It is, no doubt, faster than the 400X. Tracks good. And it sounds really cool. The sound is the best part.
But the flight time is short. To be expected with 2...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-20-2003, 10:28 PM
Replies: 7
Views: 1,401
Posted By NV Flyer

RE: 9C Snap Roll Switch

I have the snap roll function programmed on a couple models in my 9C. The trainer switch activates it.
Where you see the OFF/INH values, OFF means its ready until you pull the trainer switch down....
Forum: RC Pattern Flying
09-10-2003, 04:42 PM
Replies: 24
Views: 2,593
Posted By NV Flyer

RE: Venus 40 and Aresti 40

I just finished my second Venus. The 1st one has a OS FS70. Plenty of power. But is nose heavy with that engine. I so far have 1 1/2 oz on the tail, and battery behind the servo tray to balance. It...
Forum: Batteries & Chargers
08-25-2003, 04:13 PM
Replies: 5
Views: 504
Posted By NV Flyer

NimH & Hobbico MKII Problem, HELP

I think that charger is set to time out at 2 hours, charged or not. Anyone know for sure?
Forum: ARF or RTF
08-10-2003, 03:03 AM
Replies: 159
Views: 22,314
Posted By NV Flyer

Moki

I put a Moki 1.35 in mine. Only have a few flights on it, but seems like it has plenty of power for the plane. Wasn't looking for 3D from it. I added no weight to balance. Battery is just behind the...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-21-2003, 05:32 PM
Replies: 6
Views: 1,250
Posted By NV Flyer

Polyswitch info

Tower sells them also.

http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXCUG9&P=7
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-19-2003, 10:34 PM
Replies: 61
Views: 6,218
Posted By NV Flyer

Warning: BAD service from Servo City

Thank you for your warning.
I do trust my own experience more than yours.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-19-2003, 09:33 PM
Replies: 61
Views: 6,218
Posted By NV Flyer

No Problem

The orders I have placed with Servo City have always been trouble free, and usually arrived faster than I expected.
I won't hesitate to order from them again.
Forum: RC Helicopter General Discussions
04-08-2003, 05:37 PM
Replies: 16
Views: 1,266
Posted By NV Flyer

Can I use a Futaba 9CHF on Realflight G2?

I use my 9C with G2.
You will need the adaptor listed in post#8.
I have always removed the TX module when controlling G2 with the radio. No worry about burning it up then. Or you could extend the...
Forum: Batteries & Chargers
04-05-2003, 04:28 AM
Replies: 3
Views: 655
Posted By NV Flyer

What type of charger for Hobbico LC 7 Ah battery

I second the Battery Tender. I have been using the Battery Tender Plus on 4.5 , 7 , and 18 Amp lead acid batteries.
It works really well. No worry about charging time or rate. Just connect it and...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-02-2003, 08:27 PM
Replies: 6
Views: 1,258
Posted By NV Flyer

Futaba 9CAP vs. 9CHP (Again????)

I have the 9C heli radio. I only own one heli, but have several planes.
There is no difficulty flying the planes with the 9CH. I originally had a 9CA and didn't like flying the heli with it. So...
Forum: RC Helicopter General Discussions
04-02-2003, 03:31 AM
Replies: 23
Views: 3,267
Posted By NV Flyer

Heliproz vs. Heli-World

I have ordered from both with no problems. Heliproz are good to deal with over the phone. I prefer to order from them. But Heli World is closer and I get regular UPS from them the next day.

No...
Forum: Glow Engines
03-30-2003, 06:49 AM
Replies: 4
Views: 1,778
Posted By NV Flyer

MOKI 135 Muffler

Here is the link to the Bisson website:

http://bissonmufflers.com/en/index.html

I have a Moki 1.35 in mine and used the 1120 muffler.
It fits with no problems.
Forum: Batteries & Chargers
03-30-2003, 06:13 AM
Replies: 13
Views: 990
Posted By NV Flyer

(Not really) independent chargers (HQFC Mark2)

I will take a stab at this.
The Mark II will charge 2 batteries independantly. Like a 1 cell glow starter on one side. And an 8 cell transmitter on the other side. Each with its own charge rate. No...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
03-29-2003, 08:41 AM
Replies: 2
Views: 454
Posted By NV Flyer

Servo test function? Help.

The servo test function of the 9C will only command the servos connected to the receiver to move through their range. There is no feedback to the radio that indicates if they are working properly. ...
Forum: RC Helicopter Beginners Forum
03-19-2003, 06:15 PM
Replies: 3
Views: 646
Posted By NV Flyer

Futaba 6XAS

I have been using a 6XAS to fly my heli.
Works fine for learning hover and forward flight. I put a piece of fuel line on the throttle ratchet to make it smooth.
I set up the linkages on the heli...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-26-2003, 01:18 AM
Replies: 3
Views: 571
Posted By NV Flyer

First time buyer needs help

I have 2 400X Zagi's. I don't have experience with the others you were asking about.
I can say I am happy with the 400X. They are really easy to fly. I have handed my radio to a friend who has...
Forum: Batteries & Chargers
02-25-2003, 03:41 AM
Replies: 71
Views: 6,738
Posted By NV Flyer

An Idea

Could you put a variable resistor in there? And adjust it while measuring current with a multimeter.
Then either leave the pot in or replace it with a fixed resistor of the correct value. ...
Forum: Batteries & Chargers
01-10-2003, 05:17 AM
Replies: 9
Views: 881
Posted By NV Flyer

Should I be concerned??

It may have been discharged before the flight. Is that what led to the crash? Or was it another problem. If it went straight into discharge on the Accu-Cycle, it was dead to start with.

First...
Forum: Beginners
01-06-2003, 03:09 AM
Replies: 5
Views: 587
Posted By NV Flyer

Question for the prop experts

I have been using clear Top Flight LusterKote to balance my props. Spray it on the light blade of the prop. Keep adding coats until it balances. Usually doesn't take much.
This method doesn't...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
01-05-2003, 08:54 AM
Replies: 2
Views: 814
Posted By NV Flyer

unpacked

This is about everything as it comes out of the box.
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
01-05-2003, 08:48 AM
Replies: 2
Views: 814
Posted By NV Flyer

Inside box

Open the box .
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
01-05-2003, 08:47 AM
Replies: 2
Views: 814
Posted By NV Flyer

V2 Pro Build/Assembly

This is my first heli. I have been flying planes for 2 years and thought it was time for a helicopter.
Probably just going to post mostly pics since this one goes together fast and needs little...
Forum: Thunder Tiger - Raptor 30, 50, 60, 90
01-05-2003, 08:27 AM
Replies: 11
Views: 1,651
Posted By NV Flyer

Any luck?

Do you have a glow plug in the engine? Just thought it may be the wrong one. Meaning to long, and striking the piston. Preventing the crankshaft from turning 360 degrees.
Just an idea.
Showing results 1 to 25 of 49
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.