iamrandy

Hello,
i have figured out how to P mix my rudders with the nose gear, but when i want to use them for speed brakes ( both rudder servos movng in the opposite direction ), they both still move in the same direction.
Help?
Thank You

mglavin

My Feedback: (31)

Please provide the programming steps you've utilized to effect the rudder mixes.

Off the top of my head I'd suggest you have to change the travel percentages ( + or - ) when the speed brake is deployed.

iamrandy

Channel 4 right rudder
Channel 6 nosewheel
Channel 7 left rudder

P mix # Master slave

1 4 6

2 4 7

3 5 4

4 5 7

as i said earlier, i do get rudders and nosewheel proper. when i wish to use the rudders for speed brakes, i would like the rudder servos to move opposite to each other.
again, Thank You for your assistance.

mglavin

My Feedback: (31)

I'll play with your set-up and see if I can figure it out... Give me a little time to get some gear on the bench and mock it all up.

iamrandy

Mike--
I can't ask for more than this. Thank You for your time and efforts. I am looking forward to seeing your results.
randy

mglavin

My Feedback: (31)

I was able to get it to work, se below for my set-up. You may require different values, but it proves it works.

pmix #4
L/U = 0%
R/U = +30%

pmix #3
L/U = 0%
R/U = -30%

To increase the travel speed brake/rudder, increase the percentages on both pmixes equally.