RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Redcat Racing Support (https://www.rcuniverse.com/forum/redcat-racing-support-427/)
-   -   Redcat Racing Volcano Thread (https://www.rcuniverse.com/forum/redcat-racing-support-427/5342027-redcat-racing-volcano-thread.html)

kuppler 01-14-2008 08:56 PM

RE: Redcat Racing Volcano Thread
 
i was going to take a pic of it right now and post but i Forgot Truck in my car.... after i get back from the GYM.. ill bring it in and take a pic....

kutzie1793 01-15-2008 07:40 PM

RE: Redcat Racing Volcano Thread
 
i need a new glow plug for a redcat racing volcano sv. whats the difference between the cold hot and medium glow plugs?

ehroof 01-15-2008 08:00 PM

RE: Redcat Racing Volcano Thread
 
answered in the other thread

chill214 01-16-2008 04:09 PM

RE: Redcat Racing Volcano Thread
 
I changed out the radio, reciever, and servos on my Volcano SV. I replaced them with the Spectrum 2.0 radio, reciever and servos. The throttle and steering response is much better. The truck also has a lot better turning radius and can go out as far as I want. The radio that comes with the truck is garbage. I guess it gets the job done if you just want to stay within 20 feet and not have very good control over the truck. I'm not bashing the truck, the truck is awesome, just a crappy radio.

uncle everett 01-16-2008 04:21 PM

RE: Redcat Racing Volcano Thread
 
My suspension travel is crushing my dogbones. I've orderd the cvds, but they are too long and also get crushed. I've limited my suspension travel by putting spacers into my suspension, but would like full travel and am wondering if you can recomend shorted cvds? 08046 is the cvd I ordered, but they won't come even close to fitting in the rear.

Thanks

Redharris 01-17-2008 01:09 AM

RE: Redcat Racing Volcano Thread
 
Thats odd. Ive got a Volcano SV. I put on T-Maxx shocks (slightly more travel than Stock) and my dogbones have enough endplay throughout range of suspension.

nitrozach54 01-17-2008 12:27 PM

RE: Redcat Racing Volcano Thread
 
http://i1.tinypic.com/6jcegas.jpg
would this engine work in the volcano?

ehroof 01-17-2008 12:58 PM

RE: Redcat Racing Volcano Thread
 
its a slide carb, you need a rotary carb to make it easier to install, if its a .18 or smaller it should fit, you also have to make sure it has a standard crank on it too.

nitrozach54 01-17-2008 01:26 PM

RE: Redcat Racing Volcano Thread
 
hahah its a .28
lotsa power
thanks for the help

ehroof 01-17-2008 02:23 PM

RE: Redcat Racing Volcano Thread
 
i thought so, lol. thats why i said "if". I dont think axial makes a small block, i may be wrong though.

ehroof 01-17-2008 02:25 PM

RE: Redcat Racing Volcano Thread
 
ok, i am wrong, they make a .12

http://www.axialracing.com/details.php?Id=3324

uncle everett 01-17-2008 03:41 PM

RE: Redcat Racing Volcano Thread
 
I'm bending dogbones constantly, and I'm breaking axle ends left and right! The dogbones I buy are ae and are about 1.5mm shorter then I put a spring inside to keep them in the outer cups. I need cvds, but redcats are too long and won't allow full suspension travel in the front and nearly any in the rear! Does redcat or hpi or anyone make a cvd that is about 2mm shorter then the redcat p/n 08046?

ehroof 01-17-2008 06:20 PM

RE: Redcat Racing Volcano Thread
 
what rc do you have that keeps bending and breaking dogbones? i have had my volcano stx and tornado xp for 2 years and never broke or bent a dogbone

uncle everett 01-18-2008 10:13 AM

RE: Redcat Racing Volcano Thread
 
An exceed dynamite. If you crush the front suspension, the dogbones bottom out and bend. I've tried their universals, but they are too long as well. Any ideas.

Livlrge

ehroof 01-18-2008 10:16 AM

RE: Redcat Racing Volcano Thread
 
did you put a small piece of fuel tubing in each drive cup to take up the slack? you need to leave a little slack but you need to keep it even with 2 pieces of tubing

tornadobb666 01-18-2008 08:38 PM

RE: Redcat Racing Volcano Thread
 
My volcano SV transmission gears teeth are all ate up, from when I took the engine off and put it back on. How do I know where to realign the engine where it won't happen again.

barkersrock 01-20-2008 11:30 AM

RE: Redcat Racing Volcano Thread
 
i just recently bought my son a volcano stx ...the radio that came with it is basically junk..
i am new to the whole rc thing ivebeen lookin on ebay for a new radio but really dont have a clue !!
if any one could help me out here that would be great

Macanan 01-20-2008 11:37 AM

RE: Redcat Racing Volcano Thread
 
Here's a good one

http://cgi.ebay.com/FUTABA-2PL-FM-TR...QQcmdZViewItem

barkersrock 01-20-2008 12:04 PM

RE: Redcat Racing Volcano Thread
 
alright thanks..when you replace the radio do you also replace the reciever / servos ??

Macanan 01-20-2008 12:13 PM

RE: Redcat Racing Volcano Thread
 
The receiver yes servo's no unless you want to, which I replaced it all transmitter receiver and servo's

barkersrock 01-20-2008 12:32 PM

RE: Redcat Racing Volcano Thread
 
NOW I GET IT

Macanan 01-20-2008 12:39 PM

RE: Redcat Racing Volcano Thread
 
Most of the remote cars you get will have 27mhz crystals, which can only be used with a 27mhz transmitter and receiver, thats why I upgraded my transmitter and receiver to a 75mhz, it allows you to drive it at a farther distance and used my same servo's till I got new one's, which by the ebay link I posted gave it all transmitter receiver and servo's. I'm not sure of the mhz though 75 or more is what you want.

Macanan 01-20-2008 12:40 PM

RE: Redcat Racing Volcano Thread
 
Just searched it that package deal is a 27mhz

barkersrock 01-20-2008 12:49 PM

RE: Redcat Racing Volcano Thread
 
cool i was wonderin about the mzh..so the higher the mzh the more distance
the one i have is a 27.145 mzh

Macanan 01-20-2008 12:55 PM

RE: Redcat Racing Volcano Thread
 
Correct, so I would go for the 75mhz or more. Not the link I posted, its only 27mhz


All times are GMT -8. The time now is 04:42 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.