- Let's play help the Newbie!
- Mid-Upper range learning craft?
- Centuary 12/18 ESC UNIT NEED HELP 1 post 2 questions
- Larger Sized Electric for RE-Birth
- Ambrosia flight simulator
- Which Brushless?
- bought the wrong helicopter
- How to for Newbie Pilot !
- V3 Lama Woes
- Micro Xcopter
- ignore
- Falcon 3D Blade Balancing
- 3D Mode On The Falcon 3D
- Anyone experience with flying backwards and forwards the Double Horse 9081 Electric Helicopter?
- I'm an impulse buyer, Now I have my first Heli
- Blade pitch bugs Pictures shows it
- How do I stop tail waggle with cp pro?
- trex 450se v2 and futaba6xas
- Main rotor won't rotate
- plz help with new honey bee
- NO ONE FLYING THESE 2 NICE HELIS?
- newbie looking for a heli
- My FALCON HAS A HEART BEAT
- FALON UNUSED 2 PRONG PLUG ON ESC
- Moving On To Nitro Helis From Electric
- Falcon, Honey Bee and similar heli battery cords
- bell 430 project
- Newbie seekign info about crystals
- First timer! ahh
- Falcon 3d in Australia
- nexus 30
- Sure could use some help here
- New Align Nitro 50
- Raptor 50 v. Kyosho Caliber 50??
- Nitro heli for a beginner
- lama V4 doesn't come with charger?
- Lama Blade Question
- Just starting! Engines question
- Is the air hogs reflex worth getting?
- raptor 50 with futaba 7cap
- CONNECTING RODS DO THEY "POP OFF"
- Lipo Charge times with and without blancing
- Good, first helicopter for experienced R/C plane pilot
- Exceed Revolution 450 3D,using a futaba 14mz
- PARTS
- Raptor 30 question
- Where to mount a gyro
- speed throttle servo
- throtle curves normal and idle up, same hoovering point?
- Dynam Hughes 300 Wobble and bounce problems
- is this a good starter helicopter
- Raptor blades
- New Flyer looking for club in NVA
- Exceed 50 head assembly measurements
- Beginners Heli - Raptor 50 Titan
- Tail Servo Problem
- Looking to get a heli what should i start with
- first heli.
- How long are the run times and charge times?
- Problems with BLADE CP
- believe it or not about FALCON 3D
- gyros
- Have bad vibration but only at high rpm?
- NEED BLADE PITCH HELP
- Question:Titan 50 Setup
- Carbon Fiber Blades For The Falcon 3D
- FNG-What should I get - Esky V3 or V4?
- reciever question. futaba r146ip
- raptor g2 transmitter set up
- dragonfly 60
- WHAT THE HECK IS A BEC?
- Lipo max length and weight for Lama v4
- Trex 450 & Dx7
- Heli-Max AXE CP RTF
- BLADE TRACKING BUGS
- HONEY BEE KING GYRO BUGS
- Radio - Futaba 6EX 2.4 vs DX7
- Whats a good heli for a noob?
- non symmetrical blades
- Needing some advice
- Spektrum DX7
- DF60 tail rotor??
- Heli-Max Axe CP Micro EP RTF
- will the esky sim tx work with clearview
- FLYBAR LOCKING TOOL
- Falcon 3D, PIT/PLT What the!!!! Help~
- Training with DX7 and XTR sim
- Honeybee cp2 parts
- Main Rotor spinning clockwise? Why?
- Air Hogs Havoc top rotor weight broken - fixable?
- Blade CP Pro repair site?
- Need help Ready to call Helis quits
- Micro Hughes toy helicopter
- Its been awhile
- RAPTOR 50 TITAN - SERVOS & BATTERIES
- new 50 heli question?
- airhogs helix heli
- Falcon 3d help
- Uncontrollable Tail Spin Please HELP........
- BRUSHLESS vs BRUSH MOTOR FLIGHT TIME?
- Helidirect.com only sells parts?
- TOWER HOBBIE SHIPPING FEES ON FUEL
- Plastic control links Life span?
- BLADE PITCH ON STOCK DF60
- JR XP6102
- FALCON HEAD/ CONTROL ROD PROBLEM
- simulator to heli " technique"
- Raptor Stand
- What to Buy???
- rc helicopter stuff
- Blade pitch
- which adaptor for phoenix sim?
- SUGGESTIONS FOR A BIT BIGGER HELI
- bec circuit removal on GWS speed controller
- Radio & gyro compatibility
- Can anyone help me
- Help in flying.
- simulators
- Complete newb ?'s
- Whats the best beginners heli?
- what parts should i get w/ new Lama V3???
- Whats with Hobby-lobby prices?
- Revolution or falcon
- flight simulators
- BIG hawk problem!!
- UK-related legal question
- Havoc Air Hogs Infrared Mini RC Helicopter
- upgrade to a new heli
- Honey Bee trainer port issue
- beginner's choice
- Raptor E620SE, does anyone have one?
- Spare Parts For The Falcon 3D
- Trex, So Many Choices?????
- Smallest 4 channel electric helicopter?
- Falcon 3d In Australia without parts!!
- Looking at Honeybee Mark 3 as first helicopter
- Walkera 53#1 Parts
- AXE EZ battery used with Walkera 53#1?
- Gharger started working then Blew the battery
- Low battery crash warning & need some info
- Falcon 3D or Revolution 450
- X-Heli
- Cheaper Micron V2?
- Hummingbird V.4 vs. Rotofly ex
- New Beginners Beware!
- For the Battery experts
- HOBBY-LOBBY DID IT AGAIN
- It took time but was worth it
- is my 4 in 1 dead
- safety
- Futaba Radios with Helimax
- Charging the heli
- hawk pro tail rotor issue
- Picture of charger
- What charger?
- Question on charger that comes with Honey Bee King
- wALKERA dRAGONFLY #35 PARTS
- Eflight blade cx
- Lama V3 new 4in1 EK2-0705B
- lama v3 HELP
- 2ND TRY REQUESTING HELP
- Place to find parts for eSky Honeybee CP2
- Du-BRO Kwik-Start glow plug starter
- 2Channel Heli.........
- hbk swashplate
- Gryo not resetting Need Help
- Swash Type?? .30 Hirobo Huey
- im going to try helis now
- Falcon 3D R/C Helicopter
- hovering
- Axe CP mini EP RTF
- can i use the electrics out of my crashed jr voyager in a century swift
- OK OK OK! I order REALFLIGHT!
- battery charging
- Futaba Radios
- What comes after the PICCO or the HAVOC?
- Multiplex-Mulicharger LN-5014
- Lithium Ion vs Lithium Polymer
- Top rotor not spinning!
- SIM learning tip
- GOOD VENDORS
- Help with Colco Apache AH64 4-Channel RC helicoptor
- HOBBY-LOBBY IS THE GREATEST
- blade cp repair
- Setup of DX7 for the T-Rex 450SE V2
- Info for aluminum ungrade on Honey Bee King
- Throttle Hold
- Upgrade issues for the HBK
- Wont go to green!
- Jr Venture 30 suggestions
- Futaba 6EXH Programming to Eflite 4 in 1
- CocoLlama G5
- Balancing the battery in your Honeybee CP2
- honeybee cp2
- FALCON D GYRO GOING OUT?
- Honey Bee King Fiber type blades
- Banana Hobby
- Starter heli radio
- Getting started, looking for some info
- caliber 30
- Walkera 37 help please
- My Corona on E-bay
- Which is better......
- Help with glitch, not sure what is wrong
- ECO 8 RC HELICOPTER KIT - What is included?
- BLADE FLEX & TRACKING
- Honeybee CP2 - Should rotors spin with main gear
- trex 600 vs raptor titan
- Falcon 3 D wireing
- Why did my battery overheat and smoke during setup NOT during a charge
- No lift
- honey bee cp2
- Charging and discharging,explanation!
- need help
- need some advice please.
- Transition to outdoor flight?
- ESC Won't go into Setup Mode
- Question??
- New Pilot!
- HELP! t-rex600/dx-7 setup...frustrated
- Help with honey bee cp2 please
- New Old guy
- must be a glitch...
- Optic 6 setup for Blade CP pro?
- I thought this was a hobby we all shared
- Cx2 green light turns to red..no power
- Falcon D GRYO issues
- Saga of the HL E-Sky ESC
- Suggestions on a ESC
- WOOO HOOOO Got my new FALCON D TODAY
- Honey Bee Motor magnetic poles
- DEfective motor? Bad ESC How to check ESC?
- Transmitter power/watts?
- New FALCON D Maybe today :-)
- Tx adjustment or technique??
- New HONEY BEE KING motor problem??
- Any online, non fraud fast shipping store?
- I need some help Please
- Motor has a miss at high rpm
- Header Tank Question
- I Need Help with helihobby
- Few Questions...
- Servo problem on HoneyBee CP2
- Heli-Max MX400 EP ARF...
- Decent Beginner Heli...
- Neuter a CP Pro?
- Interested in learning electric heli's
- Blade CP Pro feels sluggish.
- Hobby Lobby Store
- E- Flite 4-in-1 assistance