RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: efretwell
Showing results 1 to 25 of 30
Search took 0.50 seconds.
Forum: Everything Diesel
02-19-2008, 03:08 AM
Replies: 7
Views: 1,123
Posted By efretwell

RE: Cold start assist

just use a hair dryer and point it at the air filter, I use this in idaho when its about 10 degrees F out, I actually heat up the whole block to.
Forum: CEN Racing
04-25-2007, 02:50 AM
Replies: 11
Views: 1,611
Posted By efretwell

RE: gst 7.7 why is it so hard to start

make sure that you aren't flooding the engine when you prime it, it only takes me one or two rotations of the crank to prime the fuel to the carb, if you continue to prime after the fuel has traveled...
Forum: CEN Racing
03-26-2007, 02:24 AM
Replies: 57
Views: 4,587
Posted By efretwell

RE: GST Working Fine, Now it wont go anywhere

Don't forgot the set screw on the front diff slider, when I first had My truck I thought that my front diff was fried for a couple of days becuase the set screw backed out and the front diff and the...
Forum: CEN Racing
10-20-2006, 01:38 PM
Replies: 0
Views: 427
Posted By efretwell

Genesis tire foams

Does anyone make foams to fit the genesis wheels, I had to replace mine once and I used panther monster truck foams, deffinently not big enough had to stretch them over the wheel. The first three...
Forum: CEN Racing
10-19-2006, 09:38 PM
Replies: 1
Views: 541
Posted By efretwell

RE: Which is better???!!!!

I have the MX-3 from the gensesis Le and I love it, it has all the electronic adjustments, and seems to work very well, unfortunately i don't know anything about the new radio.
Forum: RC Monster Trucks
10-16-2006, 04:29 PM
Replies: 9
Views: 1,000
Posted By efretwell

RE: show me wat you can do with your truck!

sometimes i push mine down the stairs, then hit the brakes and watch it flip end over end the rest of the way, but mostly a take it apart then scr*w things up.
Forum: CEN Racing
10-16-2006, 04:24 PM
Replies: 77
Views: 9,148
Posted By efretwell

RE: Fuel tank/motor issues.... Again...

I deffinently agree with CEN, and I would also like to say that my motor seems very easy to tune, and very powerfull. The one time I took it to the track, the guy at my lhs helped my get the tune...
Forum: CEN Racing
10-16-2006, 04:10 PM
Replies: 6
Views: 1,045
Posted By efretwell

RE: GENESIS Third gear trouble, HELP Anyone?

did you accidentally loosen the set screw, that is very easy to do, i did it to my brothers MGT on accident once, took me a while to figure it out.
Forum: CEN Racing
10-16-2006, 04:08 PM
Replies: 19
Views: 2,846
Posted By efretwell

RE: CEN quality and tunability questions

I have had my genesis LE since last january, it was my first non radio shack rc. I have definently learned a lot from it, but it ALWAYS has ran great for me, half the time it starts on the first pull...
Forum: CEN Racing
10-16-2006, 04:04 PM
Replies: 1
Views: 510
Posted By efretwell

RE: 2nd & 3rd Gear Adjustable Screws

they are push down on to ball bearings which hold the clutch pack to the metal piece which it sits on, those need to be snugged then baked out 1/8 of a turn. they basically keep the clutch pack from...
Forum: CEN Racing
10-16-2006, 04:01 PM
Replies: 15
Views: 2,015
Posted By efretwell

RE: honest answers about cen genesis

I have had my genesis LE since last january, it was my first non radio shack rc. I have definently learned a lot from it, but it ALWAYS has ran great for me, half the time it starts on the first...
Forum: RC Monster Trucks
09-16-2006, 02:22 AM
Replies: 77
Views: 4,091
Posted By efretwell

RE: We want to see your trucks

Hey that truck with the Vandals stickers is bad ass, I go to schoold in Moscow also, I haven't seen it or heard it around. Me and my three room mates all have monster trucks (2 T-maxx, Savage, and...
Forum: CEN Racing
09-16-2006, 01:47 AM
Replies: 44
Views: 3,287
Posted By efretwell

RE: MTM Brake Retro-fit to a Geni LE

Every body seems to be able to flip their trucks by hitting the brakes with the MTM brake system, mine wont even lock up the tires, so I think something might be out of adjustment, so I was wondering...
Forum: CEN Racing
09-13-2006, 07:45 PM
Replies: 44
Views: 3,287
Posted By efretwell

RE: MTM Brake Retro-fit to a Geni LE UPDATE!!!!

I bought the cen kit (gss11) and the correct linkage, and I have had it installed for about 6 months, I was impressed with it after I installed it, but I only managed one brakey (much to my...
Forum: RC Monster Trucks
09-04-2006, 09:38 PM
Replies: 14
Views: 740
Posted By efretwell

RE: Maxx in sand.

Just drive it, have fun, I drive my genesis in all sorts of stuff, heck I have driven my genesis in 5 inches of drainage ditch water with my friends t-maxx, other then some soggy tires everything was...
Forum: CEN Racing
08-01-2006, 06:47 PM
Replies: 10
Views: 1,043
Posted By efretwell

RE: annoyed with locktight on Nemesis diff case

I worked on the front diff and the rear diff with three seperate torches, I would heat a screw with one torch until the lighter was to hot then I would switch torches, after going through a lot of...
Forum: Traxxas Monster Truck forum
05-30-2006, 09:57 PM
Replies: 3
Views: 393
Posted By efretwell

RE: tmaxx tranny question

i have the spur gear just as you specified and i also have friction pads in it too, and i have messed with the carb settings alot too with no change, i could tell when it was bogging down, maybe...
Forum: Traxxas Monster Truck forum
05-30-2006, 03:47 PM
Replies: 3
Views: 393
Posted By efretwell

tmaxx tranny question

got a questions here is the specs on my truck first
tmaxx 1.5 stock most everything, spool in the rear and metal driveshafts but thats it,
the problem:
when iam driving my truck and try to...
Forum: RC Monster Trucks
04-19-2006, 03:11 AM
Replies: 12
Views: 772
Posted By efretwell

RE: genesis questions

The pullstarter is fine on the genesis, Mine starts within one or two pulls most of the time. Only a few times have I cranked on it for minutes at a time, and that was becuase I was dumb. I would...
Forum: RC Monster Trucks
04-18-2006, 08:26 PM
Replies: 4
Views: 647
Posted By efretwell

RE: genesis engine

I have a genesis LE and I run it all the time with my friends. They include two t-maxxes and a SS savage. The genesis almost always is started first even with the pull start, and it never seems to...
Forum: RC Monster Trucks
04-16-2006, 09:04 PM
Replies: 16
Views: 4,123
Posted By efretwell

RE: Ungluing Tires?

I have tried the acetone method before, and it is mean it attacked the crome of my rims very hard, and it kinda burns. A Better solution is to use "OOPS", it is a cleaning agent used for removing...
Forum: CEN Racing
02-28-2006, 05:28 PM
Replies: 6
Views: 710
Posted By efretwell

RE: Nemesis Axle, Well, I did it. HELP!

wow, I didn't know that they could break that easy, I have bashed mine very hard and have had no problems. Heck I have rolled so hard that the LE roll bar is bent to the side. The axles look strong...
Forum: CEN Racing
02-28-2006, 05:25 PM
Replies: 8
Views: 815
Posted By efretwell

RE: Nemesis Tranny ?'s

I have a genesis LE and I was worried about the hole where the reverse shifter is located so I tried to make a custom flexible cover out of a balloon and sealant, it didn't come out very well. So...
Forum: CEN Racing
02-28-2006, 05:19 PM
Replies: 3
Views: 501
Posted By efretwell

RE: diff screws

I tried to loosen the diff screws with three torch lighters (two of which where tripple flame torches) multiple times. I eventually gave up becuase I wanted to drive the truck and was tired of...
Forum: CEN Racing
02-28-2006, 06:09 AM
Replies: 34
Views: 4,125
Posted By efretwell

RE: Diff lock

I tried to remove the diff screws multiple times, on two different differentials, but unfortunatelly had no luck. Those stupid screws have so much red threadlock on them that it would take large...
Showing results 1 to 25 of 30
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.