RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: 1QwkSport2.5r
Showing results 1 to 25 of 500
Search took 0.68 seconds.
04-16-2024, 11:54 AM
Replies: 2
Views: 157
Posted By 1QwkSport2.5r

I got some photos of my OFNA starter box. To...

I got some photos of my OFNA starter box. To correct my last post, I use a 4-cell Li-Ion pack to power the starter motor and a 2-cell Li-Ion pack to power the bucking converter to drive the glow...
04-15-2024, 03:17 AM
Replies: 2
Views: 157
Posted By 1QwkSport2.5r

Get your post count up so you can post photos, or...

Get your post count up so you can post photos, or use an image hosting site like Postimg to link the photos. I forget the model numbers of the various OFNA boxes, but I have one that’s all wired...
04-15-2024, 03:13 AM
Replies: 9
Views: 2,131
Posted By 1QwkSport2.5r

Considering this thread is 17 years old, you...

Considering this thread is 17 years old, you likely won’t get a response. If these parts are still available, a google search should help. If parts are NLA, then eBay is your friend,...
04-06-2024, 04:41 AM
Replies: 1
Views: 204
Posted By 1QwkSport2.5r

I don’t think there is much of a difference...

I don’t think there is much of a difference between the transmissions other than capability. Personally, I’d find a 2spd transmission without reverse. The reverse just adds weight. You might...
Forum: Glow Engines
03-30-2024, 01:27 PM
Replies: 2,331
Views: 322,569
Posted By 1QwkSport2.5r

I have quite a few ST engines. They’re very...

I have quite a few ST engines. They’re very nice quality engines and run very strong.

I have an S25 ABC, S29 ABC (ringed converted to ABC), (2) GS45 ABC, Como .51 ABC SCH, S90K Ring. The...
Forum: Glow Engines
03-03-2024, 06:51 AM
Replies: 50
Views: 12,978
Posted By 1QwkSport2.5r

If more power is what you’re after, I’d suggest...

If more power is what you’re after, I’d suggest doing some testing with your fuel, glow plug, and prop. Adding nitro, reducing prop load, and cooling the plug down will usually net more power, to a...
Forum: Glow Engines
02-28-2024, 07:28 PM
Replies: 50
Views: 12,978
Posted By 1QwkSport2.5r

A fuel pump isn’t going to increase top end...

A fuel pump isn’t going to increase top end power. It might even things out from full tank to empty, but that’s about it. If you need a boost in top end power, dump the Saito and get a YS.
Forum: RC Airboats
02-28-2024, 03:39 PM
Replies: 11
Views: 4,500
Posted By 1QwkSport2.5r

I have decided to switch gears a bit on this...

I have decided to switch gears a bit on this project; instead of killing the bow part from solid wood, I’m going to either use a Balsa core or a foam core and glue sheets of veneer to the core. This...
Forum: Glow Engines
02-17-2024, 11:43 AM
Replies: 6
Views: 1,449
Posted By 1QwkSport2.5r

I would entertain trying RCBearings.com instead. ...

I would entertain trying RCBearings.com instead. I’ve never had an issue with their bearings, and they’re usually cheaper than Boca (Boca and OS to hand in hand for being overpriced IMHO).
02-17-2024, 06:12 AM
Replies: 7
Views: 336
Posted By 1QwkSport2.5r

Don’t post any personal information, and don’t...

Don’t post any personal information, and don’t send any money to anyone via those cash apps. PayPal or Postal money orders are the only way I pay, and I do not answer to any emails soliciting hobby...
02-16-2024, 11:47 PM
Replies: 7
Views: 336
Posted By 1QwkSport2.5r

When RCU upgraded their software and did some...

When RCU upgraded their software and did some server switching some time ago, some new features came with the upgrade; the user title banners like “premium member” and “trading plus member”. You can...
Forum: Glow Engines
02-15-2024, 11:17 PM
Replies: 2
Views: 319
Posted By 1QwkSport2.5r

Most pullstarts for small block engines will fit,...

Most pullstarts for small block engines will fit, but the determining factor is the one-way clutch bearing shape and size and if the one-way clutch bearing is external to the engine or internal. ...
Forum: Glow Engines
02-15-2024, 11:11 PM
Replies: 13
Views: 862
Posted By 1QwkSport2.5r

I don’t use OS plugs because other brands perform...

I don’t use OS plugs because other brands perform so much better. I get a laugh whenever counterfeit OS glow plug threads pop up. :D:D
Forum: RC Airboats
02-11-2024, 06:13 AM
Replies: 111
Views: 12,208
Posted By 1QwkSport2.5r

I’m bringing this bad boy to the top in hopes of...

I’m bringing this bad boy to the top in hopes of resurrecting this boat and getting it right. It doesn’t ride on the step like it should. I’m not sure if the step is in the wrong place and the...
Forum: Glow Engines
02-05-2024, 06:46 PM
Replies: 3
Views: 284
Posted By 1QwkSport2.5r

Firstly, what is the problem with your carb that...

Firstly, what is the problem with your carb that came with the engine? There isn’t much to rebuilding it, really. At most, replacing the o-rings on the needle valves is about all you can replace....
02-05-2024, 06:26 PM
Replies: 3
Views: 1,918
Posted By 1QwkSport2.5r

With Jato suspension on it, really nicely all...

With Jato suspension on it, really nicely all things considered. The biggest issue is keeping it right side up. Not easy to do with a 3.3 on board. Gearing it to keep the front end planted just...
02-02-2024, 08:15 PM
Replies: 2
Views: 344
Posted By 1QwkSport2.5r

The Force .28 is made by a different...

The Force .28 is made by a different manufacturer. In a nutshell, no, you can’t put just any old .28 P/L into your engine. The Force engines are not that great, and hardly worth rebuilding. I...
Forum: Glow Engines
01-21-2024, 04:12 AM
Replies: 18
Views: 828
Posted By 1QwkSport2.5r

Make sure you’re not getting Nucleation bubbles...

Make sure you’re not getting Nucleation bubbles between the carb and remote needle. Making sure the prop blades and hub are balanced perfectly helps this quite a bit. In some cases, the remote needle...
Forum: RC Airboats
01-20-2024, 05:34 AM
Replies: 11
Views: 4,500
Posted By 1QwkSport2.5r

Here is my initial drawing. Basically just a...

Here is my initial drawing. Basically just a sketch. I need to make some changes before I draw up the CAD file to cut the bow out of cherry. My drawing puts the LOA at about 25”, which is what I...
Forum: RC Airboats
01-14-2024, 05:47 AM
Replies: 11
Views: 4,500
Posted By 1QwkSport2.5r

I’m bumping this old topic up. I think I’m...

I’m bumping this old topic up. I think I’m getting closer to revisiting the drawing and getting some dimensions figured out. I want to be as close to scale as I can - something I’ve never really...
01-13-2024, 05:37 AM
Replies: 3
Views: 380
Posted By 1QwkSport2.5r

I wouldn’t bother with finding parts for the old...

I wouldn’t bother with finding parts for the old OS. If they can even be found, they’ll cost more than the engine is worth. Quite honestly, I would look for a Novarossi or Picco .12 or .15. ...
Forum: Glow Engines
01-10-2024, 06:04 PM
Replies: 27
Views: 1,312
Posted By 1QwkSport2.5r

It just doesn’t end. The guy is clearly never...

It just doesn’t end. The guy is clearly never happy.

Oh well. Let’s move on.
Forum: RC Airboats
01-10-2024, 02:35 PM
Replies: 32
Views: 1,098
Posted By 1QwkSport2.5r

Me too. My oldest boys are 10 & 6. I built my...

Me too. My oldest boys are 10 & 6. I built my 10yr old an SI Tapered Flat Bottom several years ago. It’s a good kid-friendly boat with a .25 or .30 on it. It’s a bit of a handful with a .46 and tuned...
01-09-2024, 10:18 PM
Replies: 1
Views: 523
Posted By 1QwkSport2.5r

You won’t find any gas kits because nitro engine...

You won’t find any gas kits because nitro engine size gassers suck. The bigger gas engines run fine, but require too big of a car to be worthwhile (1/5th scale). I’m the opposite of you - gas stinks...
Forum: Glow Engines
01-09-2024, 08:16 PM
Replies: 27
Views: 1,312
Posted By 1QwkSport2.5r

I got the lecture on the other forum. ( LoL!! )....

I got the lecture on the other forum. ( LoL!! ). Never a dull moment.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.