View Full Version : Beginners
- Water jet thruster motor size?
- Best airfoils fo long flights
- Cleaning up an old glow engine
- 3200 mah and 5000mah in eflite apprentice
- Need advice- new to planes
- Will this combo work?
- ESC calibration problem
- Apprentice STTS or Mini Apprenntice
- Carbon-z Cub with DX8 2nd Gen transmitter
- designing rc plane
- More than one way to skin a cat...
- Brushless Motor not Reaching Max RPM
- Tower Hobbies TS-51 servos
- YS muffler problem
- YS RC Airplane Muffler problem
- What happened to all the glow powered trainers?
- Throttle stick question for ZLRC (The Beast)
- Proposed Fiberglass RC Airplane with a 1.5hp diesel engine.
- EFlite Safe Mode - Adjusting Gain
- Beginner progressing nicely
- airhogs rc plane mid 2000's
- OS 46 IsoSmooth mount rubber crumbled
- Modeltech Magic Electric
- Cross like symbol on a Lucky Stick
- Super Cub kits?
- Building board for kit?
- New to RC aircraft and just bought a kit
- Long range / flight time with parallel batteries & other questions
- Apprentice S 15e Starting problem
- kill switch
- Axle Screw???
- Horizon Hobby Flight School
- AR620 Receiver compatibility
- Airtronics New Era 40 instructions Needed
- New To Hobby
- New to the group.
- I need a muffler
- Getting back into RC planes
- Just for a second or two
- Have equip, need plane recommendation
- Another Old Plane Being Brought Back To Life
- High Power to Weight Motor
- Books, Reports... please.
- .40 Engine in Phoenix Sonic?
- Pole count
- questions about pusher props.
- build
- New to rc HELP
- Load of noooob Q's
- Scorpio Miss Moravia
- Beginner Planes with SAFE
- Modelers Work Bench
- A challenge, insane or just a bad idea
- Apprentice S rebuild
- Mystery Plane Identification and Help
- AirCore 40 Trainer Revival Project
- Recievers
- Recommendatons on electric park flyer
- Fuel proofing over paint
- Have a old/new plane and would like to ID it.
- Full Gas Engine kit RTF??
- NEED HELP binding transmitter to receiver
- Looking for training - Chicagoland
- HobbyKings "Orange" receivers
- Need a Kit, have motor, servos, receiver, esc, and transmitter.
- new flyer here! looking for advice on fixing up this air plane.
- Timber tow plane...
- My first flights
- Delayed reaction in response to control input
- Name That Plane
- Electric motor question.
- dihedral wing vs 4 ch
- New to nitro planes
- Learning to fly advise.
- 3 Channel or safe mode for beginners?
- Threaded coupler sizes
- New pilot here
- New to nitro but got electric rigs
- Looking for a giant scale trainer
- Need advice about servos
- Left turn during takeoff run
- Question about turning in banking
- Arising Star - Wings
- Coming back to the hobby and need advice
- Help getting a magister up and running
- trouble flying in advanced mode
- Hanger 9 Alpha Trainer
- Servo size
- Herr Engineering Starlite Question
- Newbie saying hello
- I bought $160 worth of used RC stuff today :)
- Smoke systems
- Help 1st Time Connecting Electronics
- Battery charging calculation formula / advice needed.
- Rudder movement - Apprentice
- No cost RC flying
- Help with Turnigy servo speed controller
- RF8 is so worth it
- Hello, Glad to know this forums.
- In Search Of - Top Flite P-51D 1/7 Plans
- Italian RC Engine ID
- What's the most affordabl 4 channel RTF trainer?
- Airplane builders in New York City
- Hey Noobs!
- I'm an old noob, back after 38 years!
- Receiver setup
- Flying an RC plane
- Apprentice went for a swim....What trainer is next?
- Help needed making RC Biplane
- How do I properly connect motor, ESC and Battery?
- A new beginning
- Help with strange Elevator Restriction - Super Cub S/DXe
- How would you?
- Returning to hobby after 15 years. Need help creating a list of needed items.
- First flight Parkflyers Decathlon - no forward thrust
- Why won’t my plane fly
- Newbie questions
- And yet another question.
- newbie here help identifying
- Plane. For beginners with no safe mode
- Which is easier/ better?
- Carbon or aluminum.
- Order of build?
- Great Planes Big Stik 40 - Tail Heavy or Thrust Angle
- AXN Floater Equivalent
- LiPo Balance, what should I trust?
- design FW 190 A8
- Oil measuring.
- Hey all, lost my first plane today.
- PT-40 MKII Plans
- Can't adjust Elevon blending ration on Hitec Optic 5
- Fuel mixture control valve setting.
- ESC wire problem
- Brushless Motors
- optokill ignition kill or kill for coil ignition
- Getting back into RC after 11 years absent
- Receiver Batteries
- Next after Champ?
- Information Regarding FPV.
- Possible cause of lack of newcomers
- dle 35 break in rpm
- spektrum AR500 receiver
- HobbyZone Carbon Cub S+ 1.3m BNF Basic don’t run
- Mode 1 or 2
- Solar Plane
- Help with choosing a small motor.
- Anybody in NW Iowa spirit lake area?
- Total noob sport cub S
- dle 35 spark plug installation
- Basics on 4 Cycle Gas Engine
- CA hinges on a used wing
- Dynam F6F Hellcat
- Registering with the FAA?
- Hugin II only availavle as electric?
- Sport cub s problem
- is this a alright beginner plane
- is this a alright beginner plane
- Aviator pro .40
- Good Nitro .40 trainer plane
- What size prop?
- Need advice for building an ARF that has no good instructions
- Still a beginner
- Help with first RC build
- Very interesting video
- Glow Field Box
- rimfire .15 motor,looking for flyer
- new battery for 808 camera..
- STARTER PROGRAM Springfield Mo area
- Where to fly
- Key chain camera, interference??
- Hello everybody,
- HELP! Identify my new plane
- Abell 26cc av 86" aircraft
- Binding Carbon Cub S+
- Trainer Build
- Float installation
- Planes pulls to right.
- ARF Electric trainer
- Battery charger
- Transmitter configuration
- aero-works P51 Wheels
- ZOHD Nano Talon...it's also a FANTASTIC RC trainer plane with beginner gyro mode
- Dried glue on outside of epo plane
- Electric to nitro question on new receiver
- new bixler 2 test fly
- Control package help for Ryan Sta
- Coming back to planes. Have to start over
- Need advice on RC setup and components
- Beginner - Looking for engine on SIG KADET MARK II
- Best Plane For Rough Terrain?
- help with receiver position?
- Getting into the hobby.
- Link Budget
- Servo wiring question
- canopy glue
- Great planes j3 piper cub.60 kit
- Flysky Ch5/6 switch turns on but not off
- Servo Question
- RC Fligth Simulators Questions?
- Looking for help?
- fiberglassing
- Firewall Hole
- New guy, looking for direction
- How do I get heading degree feedback when I've lost orientation?
- LT-40 large silver window sticker have metallic ink on it? Radio glitches
- Hi all - new member looking for advice
- fun fly with intro flights this Sat Nixa Mo
- .15 ARF trainer
- Couple Questions
- So I bought the DX6..........
- Magnum 52 XLS. 2 stroke ?
- Yellow Bee Won't Respond
- Plastic Female Mold Making for Fuselage -- Advice Needed
- Horizon tool question
- Transmitter question please
- Hi, I'm new and already have questions.
- Need help removing propeller holder
- Equipment problem
- Fueling a plane
- Adapting 1/8 sensored motor to 1/5 scale truck
- Good "0.20" size airplane for FPV flight?
- BNF Flyers
- Returning to RC
- Which is the best rc plane for beginners?
- Best biginner RC Plane
- new build phaeton II electric
- mini Apprentice vs Freewing Pandora
- Evolution 33cc gas engine
- Getting Back In to RC.. Sig LT-40... Gas or Electric?
- Any flying areas around Syracuse NY?
- Auto pilot on ChampS
- Searching for Great Planes “Reactor 1.60” canopy cover
- Buddy Box DX6i Master ---> DXe Slave
- Foam Electric sailplane for retiree.
- How often do I change my batteries in my transmitter
- is this a good carb setting
- brushless motor cell rating
- RC electric trainer plane - Hobbyking soundmodule
- g26 vrs g38
- is zenoe g26 powerful enough
- Dual rates
- Voltmeter?
- Looking to get into RC fixed-wings
- My first Large RC Plane Telemaster 40
- Wing not straight
- How to get started in FPV planes?
- Brand new nitro engine wont turn on
- Binding Problems
- What makes a good trainer
- Things that spin props: Whats changed in the last 20 years?